Módulo transceptor de fibra ótica BlueOptics PLRXPL-SE-S43-22-N-BO SFP+ LC alumínio 20g

The BlueOptics PLRXPL-SE-S43-22-N-BO SFP+ LC Aluminium 20g is a fiber optic transceiver module designed for 10G optical links over multimode fiber. The module uses an SFP+ interface and LC duplex connector in an aluminium housing, providing a compact, lightweight (0.02 kg) solution for high-speed network equipment that follows MSA SFP+ form-factor standards. It supports 10GBASE-SR class transmission with 850 nm wavelength components for short-reach optical connections and is suitable for use in switches, routers, storage systems and other devices that accept SFP+ optics.

Advantages

The module offers industry-standard SFP+ compatibility and a compact aluminium enclosure that reduces weight and aids heat dissipation. Using LC duplex connectivity and 850 nm optics, it supports short-range 10 Gbps data transmission over multimode fiber. Built and tested to MSA-aligned specifications, the transceiver provides predictable electrical and optical behaviour for interoperability with compatible network hardware. Its lightweight design and standardized interface simplify installation and replacement in populated racks and modular systems.

Suitable for

Key specifications

How to use

Install the transceiver into an SFP+ port on compatible network equipment until it latches, then connect LC duplex multimode fiber patch cords with correct polarity. Ensure the host device is configured for 10G operation and that any required software or firmware allows the use of third-party SFP+ modules. Power on the equipment and verify link status and negotiated speed via the host interface. For diagnostics, enable and read digital diagnostic monitoring (DDM/DOM) data from the host if the platform supports it.

Recommendations

Use OM3/OM4 multimode fiber for optimal short-range 10G performance and keep connectors and patch cords clean to maintain signal quality. Confirm compatibility with your hardware vendor’s SFP+ requirements and, where available, enable DDM/DOM to monitor voltage, temperature, laser bias and optical power for proactive maintenance.