Puxa-cabos Cimco 142028 preto 50 m

The Cable puller-feeder Cimco 142028 Black 50m is a 50-metre cable pulling tool designed for routing electrical cables through conduits, ducts and confined spaces. The unit is supplied in black and is intended to facilitate the process of drawing cable runs over moderate distances, offering a single, continuous pulling element that reduces the need for repeated handling during installation.

Advantages

The Cimco 142028 provides a long continuous length of 50 m that helps reach distant outlet points without splicing pulling lines. Its straightforward design improves maneuverability in confined spaces and conduits. The black finish contributes to a durable appearance and simplifies visual identification on-site. The tool is suitable for repeated use in typical electrical installation workflows and helps reduce time spent feeding cables through runs.

Suitable for

• Pulling single-conductor or multicore electrical cables through conduits
• Installation of cables in residential, commercial or light industrial settings
• Running cable through ceiling voids, wall cavities and trunking
• Site work by electricians, installers and contractors

Key specifications

• Length: 50 m
• Colour: Black
• Application: Cable pulling/pulling feeder for electrical installations

How to use

Feed the leading end of the puller-feeder through the conduit or duct to the desired exit point. Attach the cable securely to the leading end using an appropriate connector or tape to ensure a smooth transition and to prevent snagging. Pull the feed line back through the conduit with steady, even tension until the cable is fully positioned. Inspect the pull for any signs of abrasion or obstruction and reposition as necessary to protect the cable sheath during installation.

Recommendations

Use appropriate personal protective equipment and follow local electrical installation regulations. Avoid sharp bends and excessive tension on the cable during pulling. Where access is restricted, use a lubricant suitable for cable installation if needed, and inspect the puller-feeder for wear before each use.