Transcend JetRAM - DDR4 - módulo - 16 GB - DIMM 288-PIN

The Transcend DDR4 16GB 3200MHz 2x8GB memory module kit provides 16 GB of DDR4 system memory arranged as two 8 GB DIMMs. Designed for desktop PCs and compatible workstations, the modules use a 288-pin DIMM form factor and operate at a rated frequency of 3200 MHz with a CAS latency of 22 and a standard operating voltage of 1.2 V. This balanced specification supports faster data transfer and responsive multitasking for everyday computing, creative work, and gaming workloads.

Advantages

This DDR4 memory kit offers a straightforward capacity upgrade with dual-channel potential when installed in appropriate motherboard slots. The 3200 MHz clock speed and DDR4 architecture deliver improved throughput and lower power consumption compared with earlier generations. The 288-pin DIMM format ensures broad compatibility with modern desktop motherboards that support DDR4 memory, while the 1.2 V operating voltage helps maintain stable operation and energy efficiency.

Suitable for

Key specifications

How to use

Power down the PC and disconnect power before installing the memory modules. Open the system chassis and locate the DDR4 DIMM slots on the motherboard. Consult the motherboard manual to identify recommended slot population for dual-channel operation. Align the module notch with the slot key and press firmly and evenly on both ends until the retention clips engage. After installation, reconnect power and boot the system. Confirm that the BIOS/UEFI recognizes the full 16 GB and the target frequency; enable XMP/DOCP profiles in firmware if the motherboard supports automatic memory profile configuration.

Recommendations

Install the modules as a matched pair into the motherboard’s recommended slots to enable dual-channel mode. Verify motherboard memory support for DDR4 3200 MHz and update the BIOS/UEFI if necessary. For systems where maximum stability is required, run a memory diagnostic utility after installation to check for errors.