Cabo DMX EUROLITE 2x0,22 mm 100 m

EUROLITE DMX cable 2x0.22 mm on a 100 m spool is a shielded two-core cable engineered for DMX lighting control and reliable signal transmission. The construction includes two conductors with overall shielding to reduce electromagnetic interference and maintain signal integrity over extended cable runs. This cable is suitable for permanent and temporary installations in theatres, studios, concert venues, and event rigs where consistent DMX communication between controllers, dimmers, and fixtures is required.

Advantages

The shielded two-core design minimizes noise pickup and crosstalk, supporting stable DMX data transfer across long distances. With 0.22 mm conductor cross-section, the cable balances flexibility and mechanical strength for easy routing on venues and stages. The 100 m spool provides sufficient length for most mid-size installations and reduces the need for multiple joins, while the durable outer jacket protects conductors from abrasion and handling during setup and teardown.

Suitable for

Key specifications

How to use

Install the cable by routing it between DMX controllers, dimmers, and fixtures, avoiding run-parallel routing with power cables where possible to reduce interference. Strip back the outer jacket and shielding carefully to expose the two conductors for termination with compatible DMX connectors or terminal blocks. Use proper soldering or secure screw-terminals according to the connector manufacturer’s instructions, and ensure the shield is connected to ground at one end if recommended by the installation practice to minimize hum loops. Coil surplus cable neatly on a spool to prevent kinks and mechanical stress during transport and storage.

Recommendations

For consistent DMX performance, keep the cable away from high-voltage power lines, use quality connectors, and avoid unnecessary splices. Test runs before performances and label cable ends for quick identification during setup and teardown.