Ventilador e termistor do nozzle NT Intamsys acessório

Keep your INTAMSYS FUNMAT 3D printer’s hotend running at peak thermal stability with this genuine Nozzle Fan & Thermistor NT accessory kit. Unlike generic aftermarket sensors that drift under sustained heat, this pair is factory-matched to the FUNMAT PRO 410, PRO 610 HT, and PRO 310, delivering the exact airflow and temperature feedback your printer’s firmware expects. The radial blower fan pushes 24V of focused cooling across the nozzle zone, while the stainless-steel NTC 100K thermistor reads up to 450°C with repeatable accuracy—so you can print engineering-grade filaments without sudden thermal runaway errors.

Highlights

• Complete hotend maintenance set: one radial blower fan and one NTC thermistor
• 24V DC fan with 2-pin JST-XH connector for plug-and-play replacement
• Thermistor rated to 450°C with 100K Ohm resistance at 25°C
• High-temperature resistant fan housing and stainless-steel probe for long service life
• Designed for INTAMSYS FUNMAT PRO 410, PRO 610 HT, PRO 310, and other FUNMAT series printers

In daily use

When a nozzle fan weakens or a thermistor begins to read inconsistently, print quality suffers: stringing, warping, and unexpected thermal faults become common. Swapping in this kit restores the hotend’s original cooling curve and temperature signal, letting you return to unattended long prints with confidence. The fan’s compact 50x15 mm blower design fits the stock shroud without modification, and the thermistor’s 100 mm cable routes cleanly through the existing loom. Both connectors use the same 2-pin JST-XH standard found on INTAMSYS boards, so installation takes minutes with basic tools.

Full specifications

• Product type: 3D printer hotend accessory kit
• Included components: 1x nozzle fan, 1x thermistor
• Fan type: radial blower fan
• Fan operating voltage: 24V DC
• Fan connector: 2-pin JST-XH
• Fan dimensions (approx.): 50 x 15 mm
• Fan housing material: high-temperature resistant plastic
• Thermistor type: NTC 100K Ohm
• Thermistor resistance at 25°C: 100K Ohm
• Thermistor maximum temperature: 450°C
• Thermistor cable length (approx.): 100 mm
• Thermistor connector: 2-pin JST-XH
• Thermistor probe material: stainless steel
• Compatibility: INTAMSYS FUNMAT PRO 410, FUNMAT PRO 610 HT, FUNMAT PRO 310, and other FUNMAT series 3D printers
• Function: hotend cooling and temperature sensing
• Application: replacement or maintenance part for 3D printer hotend assembly
• Installation: user-replaceable component

Final note

Genuine INTAMSYS parts ensure your printer continues to meet factory performance specifications. Keep a spare kit on hand to minimize downtime during critical production runs.